Posts made in September, 2019

Tips for Installing Floor Tiles

Are you considering a DIY floor tile installation project? That’s quite possible, provided that you follow all the step-by-step instructions for installing floor tiles as recommended by the experts. Laying floor tiles isn’t just a skill, but also an art. It’s a task that can be mastered by any homeowner if they give it ample time and do a lot of practice.  


If you’re just learning how to go about tile floor installation, start with small jobs such as doing just half the bathroom, the mudroom, and other similar areas. Leave the kitchen for now and until you’re an expert in the job. Here are some tips on how to install floor tiles on your own: 

  1. Prepare the floor. 

The first step to installing tiles is to remove the old floor covering and sweep the entire floor clean. Unless you have a concrete floor installed, you will need a cement board to serve as backer. It’s possible to install the tiles straight into the concrete floors. However, you have to level the bumps and other problem areas prior to installation. 

  1. Measure and scale. 

Be sure to accurately measure the entire with and length of the room. Find the room’s center and draw a straight line from end to end. Draw another set of lines that are perpendicular to the first ones. Make sure that you’re making squares as you go along. Adjust the lines as needed. If your lines don’t have an angle of 90 degrees, then you’re going to have problems later. Place some tiles without adding cement along the drawn lines to know what size you’re going to need for the ones next to the walls. Adjust the tile layout as necessary. 

  1. Mix the cement. 

When mixing cement, be sure to follow the manufacturer’s instructions. You can only work with a cement mixture for a certain period of time. Be sure to mix only the amount that you intend to use. Spread the cement using a notched trowel and try not to touch the lines so you can still tell where each tile should be placed. Spread only a small amount of cement a time and install a tile immediately on top of it. 

  1. Install the tilesaway. 

Lay down a row two to three tiles along the grid that you made. Work each tile to settle nicely into the cement to secure it in place. Be sure to check the height so that it’s uniform all across, but more particularly with the adjacent tile. Don’t forget to install the spacers on every corner.  Continue with spacers to spread cement and lay tile. Cut to fit some tiles if needed. Let the tiles stand for 24 hours or whatever the manufacturers say it takes for the cement to set. Only after such time, you can remove the spacers and all excess cement. 

These are the basic steps in installing tile floors. They’re not that difficult but they do require skills, expertise, and craftsmanship. If you think that tile installation is a little too complicated for you, then it’s best that you hire a floor tiling contractor to help you out.  


Read More

Things to Consider When Junking 

In the Philippines, junk has been always considered as an opportunity for many people in order to gain some income just to get a meal on the table with their families. That is why when people wanted something to do in order to have something in their table, they tend to do all the possible things in order to acquire much. They segregate all the plastics and all the metals that still can be used and can be weigh in with just the amount of $0.50 per kilo. So, they must do all the possible things in order to acquire lots and lots of junk whether it may be plastic or scrap metals that they see in some of the places. 


Same as other works, when you are planning on doing some things like junking there are still things that are needed to consider just like other things like work. These considerations are very important for this are the factors that are needed in order to have a lot of profit when you intend to make a business out of it. That is why when you are planning on segregating, eradicating and making junk as a form of business you must consider some things in order to be successful in. In this article, we are going to introduce you some things and ideas that you could consider like what Palmdale residential junk removal can do to their customers within the time.  

The first thing that you must consider when you are junking is you must first know all the things that might occur to you and the capabilities that you have. In that way, you will be able to know what are the things that will be going to happen and what are the things that you must not when you’re junking. When you are junking you must always consider first the things that are very important and that includes your health and you must always consider collecting your personal belongings. You must know what are the things that must be removed especially the things that are very much important and can be used again in the future of some times. 

You must know what are the things that are important like paperwork and other things that have more value than some of the common things that you have in time. In that way, you will be able to prevent things from getting destroyed and degrade the things that have more value it has than it has before it was junked. When you wanted to have a lot of profit when you are junking the things that are not valuable to you anymore you must also need to search the highest deal. In that way, you will be able to maximize the profit that you will receive when you are planning on junking things that has a lot of value to some.  

Same as making a business, junking also needed some consideration in order to be effective. 

Read More

Recent Comments